The front collision sensor circuit (front airbag sensor RH circuit and front airbag sensor LH circuit) is composed of the airbag sensor assembly, front airbag sensor RH and front airbag sensor LH.
The front airbag sensor RH and front airbag sensor LH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if the airbag and pretensioner should be deployed.
DTC B161A/8A is stored when a malfunction is detected in the front collision sensor circuit (front airbag sensor RH circuit and front airbag sensor LH circuit).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Test Mode / Check Mode |
|---|---|---|---|---|
| B161A/8A | Lost Communication with Front Satellite Sensor Bus | ·
The airbag sensor assembly receives a line short circuit signal, an open circuit signal, a short circuit to ground signal or a short circuit to B+ signal in the front collision sensor circuit (front airbag sensor RH circuit and front airbag sensor LH circuit). ·
Front airbag sensor RH malfunction ·
Front airbag sensor LH malfunction ·
Airbag sensor assembly malfunction |
·
Instrument panel wire ·
Engine room main wire ·
Front airbag sensor RH ·
Front airbag sensor LH ·
Airbag sensor assembly |
Does not apply to test/check mode |
Turn the ignition switch to ON, and wait for at least 60 seconds.
Turn the ignition switch off.
If a communication error occurs, DTCs for both the LH and RH sides will be stored simultaneously. To identify the malfunctioning area, turn the ignition switch off and then to ON again.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o VSC)>DTC CHECK / CLEAR
DTCs indicating communication errors will be changed to DTCs indicating errors in initialization by turning the ignition switch off and then to ON again.
Codes other than DTCs B1613/83 and B1618/84 may be output at this time, but they are not related to this check.
| Result | Proceed to |
|---|---|
| DTCs B1613/83 and B1618/84 are not output. | A |
| DTC B1613/83 is output. | B |
| DTC B1618/84 is output. | C |
A
B
C
Clear the DTCs stored in memory.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o VSC)>DTC CHECK / CLEAR
Turn the ignition switch off.
Turn the ignition switch to ON, and wait for at least 60 seconds.
Check for DTCs.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o VSC)>DTC CHECK / CLEAR
DTC B161A/8A is not output.
Codes other than DTC B161A/8A may be output at this time, but they are not related to this check.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG