Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
1.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55702A
3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
Remove the 10 bolts and front outer cowl top panel sub-assembly.
17750A
4.REMOVE INLET AIR CLEANER ASSEMBLY
17735
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
47201
8.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
Disconnect the reservoir level switch connector and disengage the clamp.
Using a union nut wrench, disconnect the 6 brake lines and remove the brake master cylinder to way tube from the brake master cylinder sub-assembly.
Do not damage or deform the brake lines during the removal procedure.
Do not allow any foreign matter such as dirt or dust to enter the brake lines.
| *1 | Master Cylinder Piston |
Remove the 2 nuts, front brake tube way and brake master cylinder sub-assembly from the brake booster assembly.
Do not hold the brake master cylinder sub-assembly by the master cylinder piston. Hold the brake master cylinder sub-assembly by its body or its reservoir when carrying it.
Do not pull out the master cylinder piston.
Do not strike or pinch the master cylinder piston, and do not cause any damage to the master cylinder piston by any other means.
When installing the brake master cylinder sub-assembly to the brake booster assembly, or when removing the brake master cylinder sub-assembly from the brake booster assembly, make sure that the brake master cylinder sub-assembly is kept horizontal or with its tip facing downward (the master cylinder piston is facing upward) to prevent the master cylinder piston from falling out.
Do not allow any foreign matter to contaminate the master cylinder piston. If any foreign matter gets on the master cylinder piston, remove it by using a piece of cloth and then apply an even layer of lithium soap base glycol grease around the circumference (sliding part) of the master cylinder piston.
Do not use any other types of grease.
47201B
9.REMOVE BRAKE MASTER CYLINDER O-RING
Remove the brake master cylinder O-ring from the brake master cylinder sub-assembly.