Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEELS
53852K
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for RHD)
51442C
3.REMOVE ENGINE UNDER COVER LH
53851Z
4.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)
51441C
5.REMOVE ENGINE UNDER COVER RH
53737B
6.REMOVE FRONT FENDER APRON SEAL LH
53736
7.REMOVE FRONT FENDER APRON SEAL RH
8.DRAIN AUTOMATIC TRANSAXLE FLUID
43502H
9.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
48810
10.SEPARATE FRONT STABILIZER LINK ASSEMBLY
89543
11.SEPARATE FRONT SPEED SENSOR
45470
12.SEPARATE TIE ROD ASSEMBLY
48069
13.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
14.SEPARATE FRONT DRIVE SHAFT ASSEMBLY
43420
15.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft assembly LH.
Do not damage the transaxle case oil seal.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
43410
16.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Separate the bearing bracket hole snap ring from the drive shaft bearing bracket.
Remove the bolt and front drive shaft assembly RH from the drive shaft bearing bracket.
Do not damage the front transaxle case oil seal.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly RH.
Remove the bearing bracket hole snap ring from the front drive shaft assembly RH.
43420G
17.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH
Using a screwdriver, remove the front drive shaft hole snap ring LH.