Home › Engine / Hybrid System › 2AR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2013.07
RM19V0EQ _51 Engine / Hybrid System _014574 2AR-FE ENGINE MECHANICAL _0073930 REAR CRANKSHAFT OIL SEAL A

2AR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

a.
A195875
0.486,1.181 0.816,1.337 0.33,0.156 10 SST 1.376,1.263 0.858,1.263 false 1.296,0.781 1.142,0.781 1.142,0.781 1.142,1.263 false 1.359,1.038 1.142,1.038 false

Using SST, hold the crankshaft pulley.

SST
09213-54015  
09330-00021  

HINT:

SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)



b.
A196849

Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly, and rear drive plate spacer.


Hide 11401L 3.REMOVE REAR ENGINE OIL SEAL

a.
A293109
2.813,1.646 2.813,1.521 2.813,1.521 3.083,1.01 false 2.74,1.667 3.052,1.823 0.313,0.156 10 *a
*a Cut Position


Using a knife, cut off the lip of the oil seal.


b.

Using a screwdriver, pry out the oil seal.

HINT:

Tape the screwdriver tip before use.


NOTICE:

Do not damage the surface of the oil seal press fit hole or the crankshaft.