1.INSPECT BRAKE CYLINDER AND PISTON
Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the disc brake cylinder assembly and/or front disc brake piston.
2.INSPECT PAD LINING THICKNESS
| *1 | Ruler |
Using a ruler, measure the pad lining thickness.
12.0 mm (0.472 in.)
2.0 mm (0.0787 in.)
If the pad lining thickness is less than the minimum, replace the front disc brake pads.
Be sure to check the wear of the front disc when replacing the front disc brake pads.
3.INSPECT FRONT DISC BRAKE PAD SUPPORT PLATE
Make sure that the front disc brake pad support plates have sufficient rebound, no deformation, cracks or wear, and that all rust and dirt are cleaned off.
If necessary, replace the front disc brake pad support plates.
4.INSPECT DISC THICKNESS
| *1 | Micrometer |
Using a micrometer, measure the disc thickness.
28.0 mm (1.10 in.)
25.0 mm (0.984 in.)
If the disc thickness is less than the minimum, replace the front disc.
5.INSPECT DISC RUNOUT
Inspect the front axle hub bearing looseness and front axle hub runout.
Click hereDrivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION
Using SST to hold the disc, tighten the disc with the 5 nuts.
| *1 | Dial Indicator |
Using a dial indicator, measure the disc runout 10 mm (0.394 in.) away from the outer edge of the front disc.
0.05 mm (0.00197 in.)
Keep the magnet of the dial indicator away from the axle hub and speed sensor.
If the runout exceeds the maximum value, change the installation position of the disc to minimize the runout. If the runout exceeds the maximum even when the installation position is changed, grind the front disc. If the front disc thickness is less than the minimum, replace the front disc.
Remove the 5 nuts and front disc.