Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
43512
3.REMOVE FRONT DISC
Click hereBrake>BRAKE (FRONT)>FRONT BRAKE>REMOVAL
4.INSPECT FRONT AXLE HUB BEARING LOOSENESS
Using a dial indicator, check for looseness near the center of the front axle hub.
0.05 mm (0.00197 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the front speed sensor.
If the looseness exceeds the maximum, replace the front axle hub bearing.
5.INSPECT FRONT AXLE HUB RUNOUT
Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolts.
0.05 mm (0.00197 in.)
Ensure that the dial indicator is set perpendicular to the measurement surface.
Keep the magnet of the dial indicator away from the front speed sensor.
If the runout exceeds the maximum, replace the front axle hub.
43512
6.INSTALL FRONT DISC
7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
8.INSTALL FRONT WHEEL