Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.04
RM19V0EQ _58 Vehicle Interior _034909 PRE-CRASH SAFETY _0163370 PRE-CRASH SAFETY SYSTEM L

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  PRECAUTION  


PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

System Name See Procedure
Parking Assist Monitor System (w/o Parallel Parking Assist Function) (Click here)



TROUBLESHOOTING PRECAUTIONS


a.

If a terminal contact point malfunction or part installation problem occurs, removal and reinstallation of the suspected part may return the system to normal. However, be aware that the normal condition may only be temporary.


b.

Before disconnecting connectors or removing/installing parts, determine the malfunctioning area by checking and writing down the vehicle condition at the time the malfunction occurred (DTC outputs etc.).


c.

Be sure to check for DTCs related to other systems. The pre-crash safety system may be influenced by malfunctions in other systems.



HANDLING PRECAUTIONS


a.

When removing and installing ECUs, sensors, switches or other pre-crash safety system related parts, perform the following:

·

Make sure that the engine switch is off unless otherwise specified in the inspection procedure.

·

After removal/installation, check for DTCs and confirm that a normal system code is output.