Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2015.04–2016.05
RM19V0EQ _V1 General _014569 INTRODUCTION _0073802 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed See page
Correct the steering angle neutral point Parking assist monitor system (w/o Parallel Parking Assist Function) (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 80 seconds*1 or 90 seconds*2 before disconnecting the cable from the negative (-) battery terminal. (for Radio and Display Type)

*1: for LHD

*2: for RHD


·

After the ignition switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation Receiver Type)




PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed See page
ECM Perform Vehicle Identification Number (VIN) or frame number registration
·

MIL illuminates

·

DTCs are output


(Click here)
Code registration (Engine immobiliser system) Engine start See the Service Bulletin for the registration method.
·

Throttle with motor body assembly

·

Cleaning the deposits from the throttle with motor body assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft

(for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Pre-crash safety system


(Click here)
Lane departure warning camera Lane departure warning camera Lane departure warning camera (Click here)
Automatic transaxle assembly
1.

Reset memory

2.

Input transaxle compensation code into ECM

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

The deterioration of fuel efficiency


(Click here)for Initialization
(Click here)for Registration
·

Valve body assembly

·

Shift solenoid valve SL3 and/or SL4


1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

The deterioration of fuel efficiency


Shift solenoid valve SL1 and/or SL2 Perform road test to allow ECM to learn
·

Large shift shock

·

The deterioration of fuel efficiency


ECM (If possible, read the transaxle compensation code from the previous ECM) Possible
1.

Reset memory

2.

Transfer transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

The deterioration of fuel efficiency


Impossible
1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

The deterioration of fuel efficiency


Skid control ECU (Brake actuator assembly) Perform system variant learning
·

Slip indicator light illumination

·

VSC disabled or malfunctioning


(Click here)
Power steering ECU assembly Assist map writing
·

P/S warning light comes on

·

EPS control


(Click here)
·

Spiral cable sub-assembly

·

Spiral cable with sensor sub-assembly

·

Steering sensor


·

Steering angle neutral point (Initialize parking assist monitor system)

·

Steering angle setting


Parking assist monitor system (w/o Parallel Parking Assist Function) for Initialization
(Click here)
for Calibration
(Click here)
Suspension, tires, etc. Rear television camera assembly optical axis (Back camera position setting)
Rear television camera assembly
·

Parking assist monitor system initialization

·

Rear television camera assembly optical axis (Back camera position setting)


Blind spot monitor sensor Blind spot monitor beam axis inspection DTCs are output (Click here)
·

Certification ECU (smart key ECU assembly)*1

·

Steering lock ECU (steering lock actuator assembly)*1

·

Electrical key transmitter (key)*1


Code registration (Engine immobiliser system)
·

Wireless door lock control system

·

Smart entry and start system

·

Engine start

·

Steering lock system


See the Service Bulletin for the registration method.
·

Transponder key ECU assembly*2

·

Door control transmitter assembly*2


Code registration (Engine immobiliser system) Engine start See the Service Bulletin for the registration method.
·

Door control transmitter*2

·

Door control receiver*2


Code registration (Wireless door lock system) Wireless door lock control system (Click here)
·

No. 1 air conditioning radiator damper servo sub-assembly*3, *4

·

No. 2 air conditioning radiator damper servo sub-assembly*3

·

No. 1 blower damper servo sub-assembly*3, *4


Initialization servo motor (Air conditioning system) DTCs are output (Click here)*3
(Click here)*4
·

Door window regulator assembly*5

·

Power window regulator motor assembly (for driver door)*5

·

Door glass*5

·

Door glass run*5


Initialize power window control system*5
·

Auto up/down function*5

·

Jam protection function*5

·

Operation function after ignition switch is turned off

·

Key-linked function*6

·

Wireless transmitter-linked function*6


(Click here)
·

Sliding roof ECU (sliding roof drive gear sub-assembly)

·

Sliding roof glass sub-assembly

·

Sliding roof drive cable sub-assembly


Initialize sliding roof ECU (pulse sensor initial position setting)
·

Automatic slide open/close and tilt up/down function of sliding roof

·

Jam protection function

·

Operation function after ignition switch is turned off

·

Key-linked function*6

·

Wireless transmitter-linked function*6

·

Sliding roof open warning


(Click here)


*1: w/ Smart Entry and Start System

*2: w/o Smart Entry and Start System

*3: for Automatic Air Conditioning System

*4: for Manual Air Conditioning System

*5: w/ Jam Protection Function on Driver Door

*6: for RHD