Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163371 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the driving support ECU assembly.

The driving support ECU assembly determines information about the vehicle in front based on data from the radar sensor, and then decides how much acceleration and/or deceleration is needed to maintain the set vehicle-to-vehicle distance.

The driving support ECU assembly also requests to apply braking.

WIRING DIAGRAM

E259149E36
1.073,0.5 2.5,0.781 1.427,0.281 10 false from IG1 NO. 3 Relay 5.99,0.51 6.104,0.667 0.115,0.156 10 false B 5.698,1.26 5.948,1.427 0.25,0.167 10 false 25 5.979,1.406 6.313,1.552 0.333,0.146 10 false GND 5.677,0.385 5.979,0.719 0.302,0.333 10 false 30 5.219,2.177 7.156,2.375 1.938,0.198 10 false Driving Support ECU Assembly 5.229,2.021 5.594,2.385 0.365,0.365 10 false I191 3.594,0.688 4.646,0.906 1.052,0.219 10 false ECU-IG1 NO. 3

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR ((POWER SOURCE)
a.
E244596C29
1.542,0.406 1.948,0.656 0.406,0.25 2.167,2.448 2.021,2.448 2.021,2.448 1.781,1.906 true 0.167,0.167 0.417,0.333 0.25,0.167 10 false *a 2.25,2.365 2.667,2.531 0.417,0.167 10 false B 1.604,0.448 2.125,0.719 0.521,0.271 10 false I191
*a Front view of wire harness connector
(to Driving Support ECU Assembly)


Disconnect the I191 driving support ECU assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I191-30 (B) - Body ground Engine switch on (IG) 11 to 14 V
I191-30 (B) - Body ground Engine switch off Below 1 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - BODY GROUND)
a.

Disconnect the I191 driving support ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I191-25 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR