Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163372 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  C1AA1  FCM Destination Information Unmatched  C1AAC  Vehicle Information Unmatched  


DESCRIPTION

When the lane departure warning camera is replaced with a new one, it acquires the country specification information from the main body ECU (multiplex network body ECU). When the country specification information in the lane departure warning camera and main body ECU (multiplex network body ECU) or ECM do not match, DTC C1AA1 or C1AAC is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AA1 FCM Destination Information Unmatched While the initial check is running with the engine switch on (IG) and the lane departure alert system is operating, country specification information in the lane departure warning camera and main body ECU (multiplex network body ECU) do not match for 3 seconds or more.
·

Lane departure warning camera

·

Main body ECU (Multiplex network body ECU)


C1AAC Vehicle Information Unmatched When the engine switch is turned on (IG) or the system is activated, the vehicle information from the ECM and that stored in the lane departure warning camera do not match.
·

Lane departure warning camera

·

ECM



CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.READ VALUE USING GTS (DESTINATION INFORMATION)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Lane Departure Alert / Data List.


e.

Read the Data List according to the display on the GTS.

Chassis > Lane Departure Alert > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Destination Information Status of the country JPN, NA, EURO, CHINA or OTHER (GEN-EXP) Actual country code -
Chassis > Lane Departure Alert > Data List
Tester Display
Destination Information
50003 355 6
Result:
Result Proceed to
Country specification information for vehicle and lane departure warning camera match A
Country specification information for vehicle and lane departure warning camera do not match B




A

2.CHECK FOR DTCS (LANE DEPARTURE ALERT SYSTEM)

B

2.CHECK FOR DTCS (LANE DEPARTURE ALERT SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR

Chassis > Lane Departure Alert > Clear DTCs
50002 355

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR

Chassis > Lane Departure Alert > Trouble Codes
50001 355
Result:
Result Proceed to
DTC C1AA1 and C1AAC are not output A
DTC C1AA1 is output B
DTC C1AAC is output C




A

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C