Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163371 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1570  Radar Sensor Malfunction  


DESCRIPTION

The millimeter wave radar sensor assembly emits radar beams toward an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between this vehicle and the object in front. This data is transmitted to the driving support ECU assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1570 Radar Sensor Malfunction The ECM detects a radar sensor malfunction signal for approximately 0.15 seconds or more while the dynamic radar cruise control is operating. Millimeter wave radar sensor assembly

CAUTION / NOTICE / HINT

NOTICE:

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT


HINT:

The millimeter wave radar sensor assembly monitors the millimeter wave circuit activation. This DTC is stored when one of the following occurs: 1) the monitor is malfunctioning, 2) an EEPROM error is detected, 3) a voltage error is detected, or 4) the radar sensor is not adjusted. When raindrops or snowflakes strike the millimeter wave radar sensor assembly face, the distance between the vehicle in front and this vehicle cannot be measured correctly. The dynamic radar cruise control system functions by detecting the beam reflections from the vehicle directly in front. In the following cases, the system may not be able to detect the vehicle in front and may not properly maintain the correct vehicle-to-vehicle distance:

·

The vehicle in front is a tall trailer.

·

There are heavy emissions from a vehicle in front or vehicles in other lanes.



PROCEDURE

1.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
a.

Adjust the millimeter wave radar sensor assembly.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCS (DTC P1570)
2.CHECK FOR DTCS (DTC P1570)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise > Clear DTCs
50002 239

d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which dynamic radar cruise control system operation is possible.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

g.

Turn the engine switch off.


Result:
Result Proceed to
DTCs are not output A
DTC P1570 is output B



A

END

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY