This DTC is stored when the scanning angle of the millimeter wave radar sensor assembly is incorrect. This DTC is also stored when the millimeter wave radar sensor beam axis is determined to be in an incorrect position.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P1572 | Improper Aiming of Radar Sensor Beam Axis | The ECM detects that the millimeter wave radar sensor assembly beam axis is in an incorrect position (0.15 seconds or more) while the dynamic radar cruise control is operating. | Millimeter wave radar sensor assembly |
When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
Adjust the millimeter wave radar sensor assembly.
Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which dynamic radar cruise control system operation is possible.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.
Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
Check for DTCs.
Turn the engine switch off.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC P1572 is output | B |
A
B