Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163371 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1615  Communication Error from Distance Control ECU to ECM  


DESCRIPTION

The driving support ECU assembly and ECM always communicate the data for vehicle general control and diagnosis function to each other via a communication line.

The driving support ECU assembly determines the distance, relative speed, and target deceleration speed based on the signals from the millimeter wave radar sensor assembly, and it sends a control demand signal to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1615 Communication Error from Distance Control ECU to ECM While the dynamic radar cruise control is either preparing for operation or operating, communication data from the driving support ECU assembly is logically inconsistent for a certain amount of time, the ECM stores this DTC.
·

Driving support ECU assembly

·

ECM



CAUTION / NOTICE / HINT

NOTICE:

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.


PROCEDURE

1.REPLACE DRIVING SUPPORT ECU ASSEMBLY
a.

Replace the driving support ECU assembly.

Click hereEngine / Hybrid System>CRUISE CONTROL>DRIVING SUPPORT ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCS (DTC P1615)
2.CHECK FOR DTCS (DTC P1615)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise > Clear DTCs
50002 239

d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which dynamic radar cruise control system operation is possible.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

g.

Turn the engine switch off.


Result:
Result Proceed to
DTCs are not output A
DTC P1615 is output B



A

END

B