Home › Engine / Hybrid System › CRUISE CONTROL › DRIVING SUPPORT ECU › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0166363 DRIVING SUPPORT ECU A

CRUISE CONTROL  DRIVING SUPPORT ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53922B 3.REMOVE FRONT PANEL GARNISH LH

Hide 67914 4.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112A 5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

Hide 62312B 6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

Hide 55318C 7.REMOVE INSTRUMENT SIDE PANEL LH

Hide 55607 8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55303B 9.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 88150A 10.REMOVE DRIVING SUPPORT ECU ASSEMBLY

a.
E302390C02
1.719,1.479 2.198,1.396 false 0.625,1.458 0.979,1.281 true 0.458,1.396 0.771,1.552 0.313,0.156 10 false *a 2.24,1.313 2.552,1.469 0.313,0.156 10 false *b
*a Clamp
*b Guide


Remove the nut.


b.

Disengage the guide


c.

Disengage the clamp.


d.

Disconnect the connector to remove the driving support ECU assembly.