Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM19V0EQ _51 Engine / Hybrid System _014581 CRUISE CONTROL _0163371 DYNAMIC RADAR CRUISE CONTROL SYSTEM C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  P1631  Communication Error from ECM to VSC  


DESCRIPTION

The ECM sends signals such as A/T information signals, dynamic radar cruise control operation signals, brake operation demand signals, and buzzer operation demand signals to the skid control ECU (brake actuator assembly) when the dynamic radar cruise control is operating. The ECM is the only component that has a function to store and output DTCs in the dynamic radar cruise control system. Therefore, if the skid control ECU (brake actuator assembly) detects a communication error from the ECM, it sends a malfunction signal back to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1631 Communication Error from ECM to VSC While the dynamic radar cruise control is either preparing for operation or operating, the ECM continuously receives a logic error signal from the skid control ECU (brake actuator assembly) for a certain amount of time, the ECM stores this DTC.
·

Communication circuit

·

ECM

·

Skid control ECU (Brake actuator assembly)



CAUTION / NOTICE / HINT

NOTICE:

The dynamic radar cruise control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the dynamic radar cruise control system after confirming that the communication systems are functioning properly.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Using the GTS, check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication system DTCs are not output OK
CAN communication system DTCs are output NG



OK

2.REPLACE ECM

NG

2.REPLACE ECM
a.

Replace the ECM with a new one.

Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>ECM>COMPONENTS


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTCS (DTC P1631)
3.CHECK FOR DTCS (DTC P1631)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR

Powertrain > Radar Cruise > Clear DTCs
50002 239

d.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which dynamic radar cruise control system operation is possible.


ii.

Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).


iii.

Push the cruise control main switch to -SET to activate the dynamic radar cruise control system.



e.

Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.


f.

Check for DTCs.

Powertrain > Radar Cruise > Trouble Codes
50001 239

g.

Turn the engine switch off.


Result:
Result Proceed to
DTCs are not output A
DTC P1631 is output B



A

END

B