The ECM communicates several signals with each sensor and ECU via CAN communication.
If there are any malfunctions in the communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | (Condition 1)
·
While the dynamic radar cruise control is either preparing for operation or operating, the ECM continuously receives a communication cut-off signal from the driving support ECU assembly for more than a certain amount of time, the ECM stores this DTC. (Condition 2) ·
While the dynamic radar cruise control is either preparing for operation or operating, the ECM continuously receives a communication cut-off signal from the skid control ECU (brake actuator assembly) for a certain amount of time, the ECM stores this DTC. |
(Condition 1)
·
Communication circuit ·
ECM ·
Driving support ECU assembly (Condition 2) ·
Communication circuit ·
ECM ·
Skid control ECU (Brake actuator assembly) |
| U0122 | Lost Communication with Vehicle Dynamics Control Module | While dynamic radar cruise control is either preparing for operation or operating, communication data from the skid control ECU (brake actuator assembly) is invalid for a certain amount of time, the ECM stores this DTC. | ·
Communication circuit ·
Skid control ECU (Brake actuator assembly) ·
ECM |
| U0123 | Lost Communication with Yaw Rate Sensor Module | While the dynamic radar cruise control is either preparing for operation or operating, the ECM continuously receives a yaw rate sensor malfunction signal for a certain amount of time. | ·
Communication circuit ·
Airbag senor assembly (Yaw rate sensor) ·
Driving support ECU assembly ·
ECM |
| U0126 | Lost Communication with Steering Angle Sensor Module | While the dynamic radar cruise control is either preparing for operation or operating, the ECM continuously receives a steering sensor communication error signal for a certain amount of time, the driving support ECU assembly sends a signal to the ECM and the ECM stores this DTC. | ·
Communication circuit ·
Steering angle sensor ·
Driving support ECU assembly ·
ECM |
| U1104 | Lost Communication with Driving Support ECU | While dynamic radar cruise control is either preparing for operation or operating and engine switch is on (IG), communication between driving support ECU assembly and front millimeter wave radar sensor assembly, ECM or skid control ECU (brake actuator assembly) stops for 1 second or more. | ·
Driving support ECU assembly ·
Communication circuit ·
Millimeter wave radar sensor assembly ·
ECM ·
Skid control ECU (Brake actuator assembly) |
Using the GTS, check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication is normal | A |
| CAN communication is malfunctioning | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING