Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch ON.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
45713A
1.INSTALL STEERING SHAKE DAMPER
Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.
84633
2.INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)
Install the cruise control switch wire.
84632
3.INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)
84523
4.CONNECT NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
84610F
5.INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
84250A
6.INSTALL STEERING PAD SWITCH ASSEMBLY
7.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
8.INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY
45100
9.INSTALL STEERING WHEEL ASSEMBLY
| *a | Matchmark |
Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.
10.CHECK STEERING WHEEL CENTER POINT
45130
11.INSTALL HORN BUTTON ASSEMBLY