Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT PADDLE SWITCH
RM19V0EQ _52 Drivetrain _014582 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0073987 SHIFT PADDLE SWITCH A

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT PADDLE SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch to ON.

·

Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch to ON.

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

·

Do not remove the steering sensor from the spiral cable.



PROCEDURE

Hide 84523 1.CONNECT NO. 1 SWITCH WIRE

a.

Connect the 2 No. 1 switch wire connectors to the 2 shift paddle switches (transmission shift switch assembly).


b.
C224820C10
2.073,0.406 2.219,0.406 2.219,0.406 2.219,0.948 false 1.406,0.417 1.292,0.417 1.292,0.417 1.292,0.948 false 1.479,0.323 1.75,0.531 0.271,0.208 10 false *1 1.885,0.323 2.177,0.583 0.292,0.26 10 false *1 0.76,1.688 1.052,1.958 0.292,0.271 10 false *a 2.583,1.708 2.896,1.99 0.313,0.281 10 false *a 0.635,2.865 0.979,3.115 0.344,0.25 10 false *b 2.885,2.521 3.198,2.792 0.313,0.271 10 false *b
*1 Clamp
*a 0 to 40°
*b 1 to 3 mm


Install 2 new clamps as shown in the illustration.


c.

Engage the 5 guides to install the No. 1 switch wire.


Hide 84610F 2.INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

a.

Engage the 4 pins and install the 2 shift paddle switches (transmission shift switch assembly) with the 2 screws.

Torque:
1.3 N*m (13 kgf*cm, 12 in.*lbf)

NOTICE:

Make sure that the brackets are securely installed.



Hide 84250A 3.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 84306 5.INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY

Hide 45100 6.INSTALL STEERING WHEEL ASSEMBLY

Hide 7. CHECK STEERING WHEEL CENTER POINT

Hide 45130 8.INSTALL HORN BUTTON ASSEMBLY