Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function) › from 2014.05
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0164269 PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function)  C1621  Back Camera Power Supply Failure  


DESCRIPTION

This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and navigation receiver assembly are not normal.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1621 Back Camera Power Supply Failure Rear television camera assembly power supply failure
·

Harness or connector

·

Rear television camera assembly

·

Navigation receiver assembly



WIRING DIAGRAM

E288974E18
1.781,0.531 2.24,0.729 0.458,0.198 10 false CA+ 1.677,0.938 2.135,1.135 0.458,0.198 10 false CGND 2.167,0.438 2.479,0.635 0.313,0.198 10 false 11 2.167,0.844 2.479,1.042 0.313,0.198 10 false 23 0.979,1.323 1.438,1.521 0.458,0.198 10 false I194 0.979,1.49 3.063,1.823 2.083,0.333 10 false Navigation Receiver Assembly 3.573,0.792 3.885,0.99 0.313,0.198 10 false * 5.146,0.438 5.302,0.635 0.156,0.198 10 false 6 5.146,0.833 5.302,1.031 0.156,0.198 10 false 5 5.354,0.542 5.813,0.74 0.458,0.198 10 false CB+ 5.354,0.938 5.813,1.135 0.458,0.198 10 false CGND 5.073,1.281 5.531,1.479 0.458,0.198 10 false T22 5.063,1.458 6.531,1.865 1.469,0.406 10 false Rear Television Camera Assembly 3.167,2.323 4.156,2.563 0.99,0.24 10 false *: Shielded

CAUTION / NOTICE / HINT

NOTICE:
·

If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function)>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function)>CALIBRATION



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the I194 navigation receiver assembly connector.


b.

Disconnect the T22 rear television camera assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I194-11 (CA+) - T22-6 (CB+) Always Below 1 Ω
I194-23 (CGND) - T22-5 (CGND) Always Below 1 Ω
I194-11 (CA+) - I194-23 (CGND) Always 10 kΩ or higher
I194-11 (CA+) - Body ground Always 10 kΩ or higher
I194-23 (CGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.INSPECT NAVIGATION RECEIVER ASSEMBLY (CA+)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT NAVIGATION RECEIVER ASSEMBLY (CA+)
a.

Reconnect the I194 navigation receiver assembly connector.


b.
E271917C80
1.521,0.188 1.969,0.479 0.448,0.292 0.833,0.708 1.219,1.125 false 1.615,0.25 2,0.438 0.385,0.188 10 false I194 0.531,0.583 1.156,0.813 0.625,0.229 10 false CA+ 0.115,0.073 0.74,0.302 0.625,0.229 10 false *a
*a Component with harness connected
(Navigation receiver Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I194-11 (CA+) - Body ground Ignition switch ACC 5.5 to 7.05 V



Result:
Proceed to
OK
NG



OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY

NG