Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION RECEIVER(for SD) › from 2014.05
RM19V0EQ _56 Audio / Visual / Telematics _014600 NAVIGATION / MULTI INFO DISPLAY _0165970 NAVIGATION RECEIVER(for SD) A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION RECEIVER(for SD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 58804A 5.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 6.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55660 7.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 8.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY

a.
E289897C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape to the area shown in the illustration.


b.
E289898

Remove the 4 bolts.


c.
E289899

Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.


d.

Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.


Hide 86211 9.REMOVE NO. 1 RADIO BRACKET

a.
E289900

Remove the 5 screws and No. 1 radio bracket.


Hide 86212 10.REMOVE NO. 2 RADIO BRACKET

a.
E289902

Remove the 5 screws and No. 2 radio bracket.


Hide 86120L 12.REMOVE NAVIGATION RECEIVER ASSEMBLY