89348
1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
Use the same procedure for all No. 1 ultrasonic sensor retainers.
| *a | Cutout |
| *b | Protrusion |
Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.
Do not damage the front bumper assembly with the protrusion when installing the No. 1 ultrasonic sensor retainer.
Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the No. 1 ultrasonic sensor retainer and surface of the front bumper assembly.
When installing the retainer, align the cutout and protrusion as shown in the illustration.
89341A
2.INSTALL NO. 1 ULTRASONIC SENSOR
Use the same procedure for all No. 1 ultrasonic sensors.
Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.
Push the No. 1 ultrasonic sensor retainer from the outside of the front bumper assembly when there is a gap between the No. 1 ultrasonic sensor retainer and the front bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.
3.INSTALL FRONT BUMPER ASSEMBLY