Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Rear Side) › from 2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0074088 ULTRASONIC SENSOR(for Rear Side) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear Side)  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR BUMPER ASSEMBLY

Hide 2.REMOVE NO. 2 LUGGAGE ROOM WIRE

HINT:

Use the same procedure for all connectors.


a.
E301648

Disengage the clamp.

HINT:

This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



b.

Disconnect the connector to remove the No. 2 luggage room wire.


Hide 89348J 3.REMOVE ULTRASONIC SENSOR CLIP

HINT:

Use the same procedure for all ultrasonic sensor clips.


a.
E301649

Disengage the 4 claws to remove the ultrasonic sensor clip.

HINT:

This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



Hide 89341A 4.REMOVE NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure for all No. 1 ultrasonic sensors.


a.
E301650

Disengage the 2 claws to remove the No. 1 ultrasonic sensor.

HINT:

This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



Hide 89348 5.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

HINT:

Use the same procedure for all No. 1 ultrasonic sensor retainers.


a.
E301651

Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper assembly.

HINT:

This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.