Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) › from 2015.04
RM19V0EQ _56 Audio / Visual / Telematics _014601 PARK ASSIST / MONITORING _0164656 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)  C1AED  Rear Sensor Communication Malfunction  


DESCRIPTION

This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the clearance warning ECU assembly, or when there is a malfunction in a rear sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AED Rear Sensor Communication Malfunction An open or short circuit in the communication line between the rear sensors and clearance warning ECU assembly or a malfunction in a rear sensor during initialization mode after the ignition switch is turned to ON.
·

Rear ultrasonic sensor circuit

·

Harness or connector

·

Clearance warning ECU assembly



WIRING DIAGRAM

E231492E55
0.292,1.885 1.781,2.302 1.49,0.417 10 false No. 1 Ultrasonic Sensor (Rear Left Sensor) 2.958,1.885 4.458,2.271 1.5,0.385 10 false No. 1 Ultrasonic Sensor (Rear Right Sensor) 5.667,1.885 6.865,2.26 1.198,0.375 10 false Clearance Warning ECU Assembly 0.292,1.729 0.552,1.875 0.26,0.146 10 false U1 2.958,1.729 3.281,1.948 0.323,0.219 10 false U4 5.667,1.729 6,1.875 0.333,0.146 10 false I82 1.219,0.51 1.438,0.656 0.219,0.146 10 false BI 1.219,1.417 1.438,1.563 0.219,0.146 10 false EI 1.219,0.958 1.438,1.104 0.219,0.146 10 false SI 3.875,0.51 4.094,0.656 0.219,0.146 10 false BI 3.875,1.417 4.094,1.563 0.219,0.146 10 false EI 3.875,0.958 4.094,1.104 0.219,0.146 10 false SI 3.177,0.51 3.469,0.656 0.292,0.146 10 false BO 3.177,1.417 3.469,1.563 0.292,0.146 10 false EO 3.177,0.958 3.469,1.104 0.292,0.146 10 false SO 5.844,0.51 6.188,0.656 0.344,0.146 10 false BOR 5.844,1.417 6.073,1.563 0.229,0.146 10 false E1 5.833,0.948 6.177,1.094 0.344,0.146 10 false SOR 1.469,0.406 1.604,0.552 0.135,0.146 10 false 1 1.469,0.833 1.604,0.979 0.135,0.146 10 false 3 1.469,1.302 1.583,1.448 0.115,0.146 10 false 5 4.135,0.406 4.25,0.552 0.115,0.146 10 false 1 4.135,0.833 4.25,0.979 0.115,0.146 10 false 3 4.135,1.302 4.25,1.448 0.115,0.146 10 false 5 2.969,0.396 3.083,0.542 0.115,0.146 10 false 2 2.958,0.833 3.073,0.979 0.115,0.146 10 false 4 2.958,1.302 3.073,1.448 0.115,0.146 10 false 6 5.552,0.396 5.729,0.542 0.177,0.146 10 false 22 5.552,0.823 5.729,0.969 0.177,0.146 10 false 24 5.552,1.313 5.729,1.458 0.177,0.146 10 false 23


PROCEDURE

1.CHECK DTC OUTPUT (C1AED)
a.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AED is output A
No DTCs are output B



A

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - REAR RIGHT SENSOR)

B

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - REAR RIGHT SENSOR)
a.

Disconnect the I82 clearance warning ECU assembly connector.


b.

Disconnect the U4 No. 1 ultrasonic sensor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I82-22 (BOR) - U4-1 (BI) Always Below 1 Ω
I82-24 (SOR) - U4-3 (SI) Always Below 1 Ω
I82-23 (E1) - U4-5 (EI) Always Below 1 Ω
I82-22 (BOR) - Body ground Always 10 kΩ or higher
I82-24 (SOR) - Body ground Always 10 kΩ or higher
I82-23 (E1) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (REAR RIGHT SENSOR - REAR LEFT SENSOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (REAR RIGHT SENSOR - REAR LEFT SENSOR)
a.

Disconnect the U1 No. 1 ultrasonic sensor connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U4-2 (BO) - U1-1 (BI) Always Below 1 Ω
U4-4 (SO) - U1-3 (SI) Always Below 1 Ω
U4-6 (EO) - U1-5 (EI) Always Below 1 Ω
U4-2 (BO) - Body ground Always 10 kΩ or higher
U4-4 (SO) - Body ground Always 10 kΩ or higher
U4-6 (EO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR)
a.
E227022C04
1.427,0.478 1.427,1.084 false 1.818,0.478 1.818,1.084 false 2.209,0.478 2.209,1.084 false 1.22,1.2 1.22,1.806 false 1.62,1.2 1.62,1.806 false 2.02,1.2 2.02,1.806 false 1.336,0.272 1.513,0.418 0.177,0.146 10 EI 2.114,0.272 2.291,0.418 0.177,0.146 10 BI 1.708,0.272 1.885,0.418 0.177,0.146 10 SI 1.126,1.836 1.355,1.982 0.229,0.146 10 EO 1.904,1.836 2.147,1.982 0.243,0.146 10 BO 1.497,1.836 1.72,1.982 0.222,0.146 10 SO 0.142,0.105 0.319,0.25 0.177,0.146 10 *a
*a Component without harness connected
(No. 1 Ultrasonic Sensor (Rear Right Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (BI) - 5 (EI) Always 10 kΩ or higher
1 (BI) - 2 (BO) Always 10 kΩ or higher
3 (SI) - 4 (SO) Always Below 1 Ω
5 (EI) - 6 (EO) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

5.REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR)

5.REPLACE NO. 1 ULTRASONIC SENSOR (REAR RIGHT SENSOR)

NEXT

6.CHECK DTC OUTPUT (C1AED)
6.CHECK DTC OUTPUT (C1AED)
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Clear DTCs
50002 170

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AED is output A
No DTCs are output B



A

7.REPLACE NO. 1 ULTRASONIC SENSOR (REAR LEFT SENSOR)

B

END (REAR RIGHT SENSOR WAS DEFECTIVE)

7.REPLACE NO. 1 ULTRASONIC SENSOR (REAR LEFT SENSOR)

NEXT

8.CHECK DTC OUTPUT (C1AED)
8.CHECK DTC OUTPUT (C1AED)
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Clear DTCs
50002 170

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AED is output A
No DTCs are output B



A

B

END (REAR LEFT SENSOR WAS DEFECTIVE)