Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
75720
2.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY
Engage the 5 claws to install the front door belt moulding assembly.
68102
3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
4.INSTALL FRONT DOOR SERVICE HOLE COVER
5.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.INITIALIZE POWER WINDOW CONTROL SYSTEM
8.INSPECT POWER WINDOW OPERATION