When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
82877
2.REMOVE ECU INTEGRATION BOX RH
89111
3.REMOVE NETWORK GATEWAY ECU
for LHD:
Disengage the 2 claws and remove the network gateway ECU.
for RHD:
Disengage the 2 claws and remove the network gateway ECU.