Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU › from 2015.04
RM19V0EQ _57 Power Source / Network _014604 NETWORKING _0074104 NETWORK GATEWAY ECU A

NETWORKING  NETWORK GATEWAY ECU  INSTALLATION  


PROCEDURE

Hide 89111 1.INSTALL NETWORK GATEWAY ECU

a.

Engage the 2 claws to install the network gateway ECU.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION