The clearance warning ECU assembly receives the reverse signal from the park/neutral position switch assembly.
Inspect the fuse for circuits related to this system before performing the following procedure.
Disconnect the I82 clearance warning ECU assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I82-27 (RL) - Body ground | Ignition switch ON
Shift lever in R |
11 to 14 V |
| I82-27 (RL) - Body ground | Ignition switch ON
Shift lever in any position except R |
Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the E79 park/neutral position switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I82-27 (RL) - E79-2 (RL) | Always | Below 1 Ω |
| I82-27 (RL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E79-1 (RB) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereDrivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>PARK / NEUTRAL POSITION SWITCH>REMOVAL
NG