Home › Drivetrain › U760E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM19V0EQ _52 Drivetrain _014582 U760E AUTOMATIC TRANSMISSION / TRANSAXLE _0073978 PARK / NEUTRAL POSITION SWITCH A

U760E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 2.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17801 4.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 84540 6.REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C239655

Disconnect the wire harness clamp.


b.
C204479

Remove the clip from the transmission cable bracket.


c.
C132236

Remove the nut and transmission control cable from the transmission control shaft lever.


d.

Disconnect the connector from the park/neutral position switch assembly.


e.
C136685

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


f.
C135732

Remove the 2 bolts and park/neutral position switch assembly from the manual valve lever shaft sub-assembly.

NOTICE:

Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral switch cannot be reinstalled correctly.