Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › from 2015.04
RM19V0EQ _58 Vehicle Interior _014606 THEFT DETERRENT / KEYLESS ENTRY _0074131 ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  B2793  Transponder Chip Malfunction  B2794  Unmatched Encryption Code  B2797  Communication Malfunction No. 1  B2798  Communication Malfunction No. 2  


DESCRIPTION

·

DTC B2793 is stored when a malfunction is found in the key during key code registration or a key code is not registered normally. Replace the key if key code registration cannot be performed normally and this DTC is output.

·

DTC B2794 is stored when a key with an incomplete key code is inserted into the ignition key cylinder.

·

DTC B2797 is stored when a key with a BCC malfunction is inserted into the ignition key cylinder.

·

DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.


DTC No. Detection Item DTC Detection Condition Trouble Area
B2793 Transponder Chip Malfunction A transponder chip malfunction. Key
B2794 Unmatched Encryption Code A key with an incomplete key code is inserted into the ignition key cylinder. Key
B2797 Communication Malfunction No. 1 A key with a BCC malfunction is inserted into the ignition key cylinder. Key
B2798 Communication Malfunction No. 2 Key code identification cannot be completed within the specified time. Key

CAUTION / NOTICE / HINT

NOTICE:

If the transponder key ECU assembly or key is replaced, refer to Service Bulletin.


PROCEDURE

1.CLEAR DTC
a.

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Check for DTCs using all registered keys.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Trouble Codes
50001 260
HINT:

If a DTC is stored, check for DTCs with the next key after clearing the DTCs.


OK:

DTC B2793, B2794, B2797 and B2798 is not output.


Result:
Result Proceed to
OK A
NG (all keys) B
NG (any key) C




A

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY

C

REPLACE KEY THAT STORED DTC