Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) › from 2015.04
RM19V0EQ _58 Vehicle Interior _014606 THEFT DETERRENT / KEYLESS ENTRY _0074131 ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)  B2795  Unmatched Key Code  


DESCRIPTION

This DTC is stored when a door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2795 Unmatched Key Code A door control transmitter assembly with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*).
·

Door control transmitter assembly

·

Transponder key ECU assembly



*: Only output while a malfunction is present.


CAUTION / NOTICE / HINT

NOTICE:
·

If the transponder key ECU assembly or a door control transmitter assembly is replaced, refer to Service Bulletin.

·

After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".



PROCEDURE

1.CLEAR DTC
a.

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Perform "DTC Output Confirmation Operation" procedure.


b.

Check for DTCs.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Smart Entry and Start System)>DTC CHECK / CLEAR

Body Electrical > Immobiliser > Trouble Codes
50001 260
HINT:

If DTC B2795 is stored, check for DTCs with the next door control transmitter assembly after clearing the DTCs.


OK:

DTC B2795 is not output.



Result:
Result Proceed to
B2795 is not output A
DTC B2795 is output for all of the door control transmitter assemblies B
DTC B2795 is output for any of the door control transmitter assemblies C



A

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY

C

3.CHECK OPERATION (IG ON)
3.CHECK OPERATION (IG ON)
a.

Check that the ignition switch can be turned to ON using the door control transmitter assembly for which the DTC was stored.

OK:

Ignition switch can be turned to ON using the door control transmitter assembly (for which the DTC was stored).



Result:
Proceed to
OK
NG



OK

4.REREGISTRATION

NG

REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY THAT DTC IS OUTPUT

4.REREGISTRATION
a.

b.

Reregister the key ID code with the transponder key ECU assembly.

HINT:

Refer to Service Bulletin.


OK:

Registration procedure can be completed.



Result:
Proceed to
OK
NG



OK

END (DOOR CONTROL TRANSMITTER ASSEMBLY REGISTRATION FAILURE)

NG

REPLACE DOOR CONTROL TRANSMITTER ASSEMBLY