Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL TRANSMITTER(w/o Smart Entry and Start System) › from 2015.04
RM19V0EQ _58 Vehicle Interior _014605 DOOR LOCK _0074112 DOOR CONTROL TRANSMITTER(w/o Smart Entry and Start System) G

DOOR LOCK  DOOR CONTROL TRANSMITTER(w/o Smart Entry and Start System)  INSPECTION  


PROCEDURE

Hide 89070E 1.INSPECT DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY

a.

Inspect operation of the door control transmitter module set sub-assembly.

i.

Remove the transmitter battery from the door control transmitter module set sub-assembly.

Click hereVehicle Interior>DOOR LOCK>TRANSMITTER BATTERY(w/o Smart Entry and Start System)>REPLACEMENT


ii.
B330066

Install a new or non-depleted transmitter battery.

Click hereVehicle Interior>DOOR LOCK>TRANSMITTER BATTERY(w/o Smart Entry and Start System)>REPLACEMENT

NOTICE:

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter from being damaged.


HINT:

When a new or non-depleted battery is not available, first connect 2 new 1.5 V batteries in series. Then connect leads to the batteries and apply 3 V to the door control transmitter module set sub-assembly, as shown in the illustration.



iii.

From outside the vehicle, approximately 1 m (3.28 ft) from the driver door outside door handle, test the door control transmitter module set sub-assembly by pointing its key plate at the vehicle and pressing a door control transmitter module set sub-assembly switch.

OK:

The door lock can be operated via the door control transmitter module set sub-assembly.

The LED comes on more than once.


·

The operational area differs depending on the user, the way the door control transmitter module set sub-assembly is held and the location.

·

The door control transmitter module set sub-assembly weak radio waves may be affected if the area has strong radio waves or electrical noise. The door control transmitter module set sub-assembly operation area may be shortened or the door control transmitter module set sub-assembly may not function.




b.

Inspect the battery capacity.

i.

Remove the battery from the door control transmitter module set sub-assembly that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.

Click hereVehicle Interior>DOOR LOCK>TRANSMITTER BATTERY(w/o Smart Entry and Start System)>REPLACEMENT

NOTICE:

Do not wrap the lead wire around a terminal, wedge it between the terminals, or solder it. A terminal may be deformed or damaged, and the battery will not be able to be installed correctly.



ii.
B330067

Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.

NOTICE:

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter from being damaged.



iii.
B330068

Check the transmitter battery voltage.

HINT:

Measure the transmitter battery voltage while pressing the lock or unlock switch on the door control transmitter module set sub-assembly.


Standard Voltage:
Tester Connection Condition Specified Condition
Battery positive (+) - Battery negative (-) Ignition switch off, all doors closed and lock or unlock switch is pressed 2.5 to 3.2 V


If the result is not as specified, replace the transmitter battery.