89170
1.INSTALL AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
| *a | Fulcrum Length |
Using SST, install the airbag sensor assembly with the 3 bolts.
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
This torque value is effective when SST is parallel to a torque wrench.
If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
When the ignition switch is first turned to ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.
| *1 | Waterproof Sheet |
Connect the connectors to the airbag sensor assembly as shown in the illustration.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that the waterproof sheet is properly set.
Check that there is no looseness in the installation parts of the airbag sensor assembly.
58861B
2.INSTALL NO. 1 CONSOLE BOX DUCT
58544A
3.INSTALL FLOOR CARPET BRACKET LH
58543B
4.INSTALL FLOOR CARPET BRACKET RH
58817A
5.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
58816B
6.INSTALL CONSOLE BOX INSERT
58804A
7.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
58916
8.INSTALL BOX BOTTOM MAT
55432D
9.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for LHD)
55432D
10.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)
53601
11.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55318C
12.INSTALL INSTRUMENT SIDE PANEL LH
62312B
13.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62112A
14.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
67914
15.INSTALL FRONT DOOR SCUFF PLATE LH
55303B
16.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
55607
17.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55317A
18.INSTALL INSTRUMENT SIDE PANEL RH
62311B
19.CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
20.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67913
21.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
22.INSTALL CONSOLE BOX ASSEMBLY
23.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
24. PERFORM DIAGNOSTIC SYSTEM CHECK
25.INSPECT SRS WARNING LIGHT