89340A
1.INSTALL CLEARANCE WARNING ECU ASSEMBLY
Engage the 2 claws to install the clearance warning ECU assembly.
82877
2.INSTALL ECU INTEGRATION BOX RH
Install the ECU integration box RH with the 2 nuts and bolt.
Connect each connector.
55303B
3.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)
55607
4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
73900
5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)
6.INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)
53601
7.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD)
55431B
8.INSTALL UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
53921B
9.INSTALL FRONT PANEL GARNISH RH
55317A
10.INSTALL INSTRUMENT SIDE PANEL RH
62311B
11.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH
62111A
12.INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
67913
13.INSTALL FRONT DOOR SCUFF PLATE RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
15.INSPECT SRS WARNING LIGHT (for RHD)