SIDE AIRBAG SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE FRONT DOOR SCUFF PLATE |
![]() |
Disengage the 10 claws and remove the front door scuff plate LH.
| 4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 5. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 6 claws and remove the rear door scuff plate LH.
| 6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
| 7. REMOVE CENTER PILLAR LOWER GARNISH |
![]() |
Disengage the 2 claws and 3 clips, and remove the center pillar lower garnish LH.
| 8. REMOVE SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Disconnect the connector from the side airbag sensor assembly.
Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

| *1 | White Housing Lock | *2 | Yellow CPA |
| *a | Slide | *b | Push |
Push down the white housing lock again and disconnect the connector.
Remove the bolt and side airbag sensor assembly from the vehicle body.
After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.

| *a | Correct | *b | Incorrect |