Home › Engine / Hybrid System ยท 2GR-FE › FUEL › FUEL PUMP ECU

FUEL PUMP ECU > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY
  1. Connect the connector and clamp.

  1. Install the fuel pump control ECU assembly with the 2 nuts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH
  1. Install the 3 clips.

  1. Engage the fastener and install the luggage compartment inner trim cover LH.



3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B281710E01
  1. Engage the 2 pins to install the 2 No. 1 luggage compartment trim hooks.
    Text in Illustration 
    *1
    Pin



4. INSTALL REAR FLOOR FINISH PLATE


    B294807
  1. Engage the 4 clips and install the rear floor finish plate.

  1. Install the 5 clips.



5. INSTALL BAGGAGE HOLDER NET (w/ Partition Net)
  1. Install the baggage holder net.



6. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).