Home › Drivetrain ยท U241E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > MANUAL SHIFTING TEST

for Preparation Click here



MANUAL SHIFTING TEST

HINT:
  1. Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.
  2. If any abnormalities are found in the following test, the problem is in the transaxle itself.



    C248662E01
  1. Turn the ignition switch OFF.

  2. Disconnect the transmission wire connector.

    HINT:
    It is possible to deactivate the electrical shift control by disconnecting the transmission wire connector. The gears can then be changed mechanically with the shift lever.

  3. Drive with the transmission wire disconnected. Move the shift lever to each position to check whether the gear changes the table below.
    Standard: 
    Shift Position
    Shifting Condition
    P
    Parking
    R
    Reverse
    N
    Neutral
    D
    No Shift (Gear will not change)

  4. Turn the ignition switch off.

  5. Connect the transmission wire connector.

  6. Clear DTCs (Click here).

HINT:
When the transmission wire is disconnected, the transaxle gear will be set as listed below.
Shift Lever
Gear
P
Parking
R
Reverse
N
Neutral
D
3rd