TILT AND TELESCOPIC MANUAL SWITCH > INSTALLATION |
| 1. INSTALL TILT AND TELESCOPIC SWITCH |
Engage the claw to install the tilt and telescopic switch.
Connect the connector.
| 2. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Engage the 2 claws to install the lower steering column cover.
![]() |
Install the 3 screws.
| 3. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Check if the spiral cable sub-assembly is centered.
![]() | Colored Part |
If the spiral cable sub-assembly is not centered, center it.
![]() |
While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.
![]() | Interlock |
![]() |
Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.
![]() | Colored Part |
![]() | Interlock |
| 4. INSTALL STEERING WHEEL ASSEMBLY |
![]() |
Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.
| *a | Matchmark |
Install the steering wheel assembly set nut.
Connect the connectors to the spiral cable sub-assembly.
| 5. INSTALL STEERING PAD |