CAN COMMUNICATION SYSTEM > Yaw Rate Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Yaw Rate Sensor Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (YAW RATE SENSOR BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
Turn the ignition switch off.
![]() |
Disconnect the connector of the yaw rate sensor.
| *a | Front view of wire harness connector (to Yaw Rate Sensor) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I172-3 (CANH) - I172-2 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I172-1 (GNDA) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Yaw Rate Sensor) |
Connect the cable to the negative (-) battery terminal.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I172-4 (IGA) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Yaw Rate Sensor) |
|
| ||||
| OK | ||
| ||