DTC P0013 Camshaft Position "B" Actuator Circuit / Open (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0013 | Open or short in camshaft timing oil control valve assembly (for exhaust camshaft) circuit (1 trip detection logic). |
|
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ OUTPUT DTC (DTC P0013) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTC after recording the freeze frame data and DTC.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON and wait 5 seconds.
Turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0013 is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (FOR EXHAUST CAMSHAFT) |
Inspect the camshaft timing oil control valve assembly (for exhaust camshaft) (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly (for exhaust camshaft) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E56-1 (+) - E26-65 (OE1+) | Always | Below 1 Ω |
| E56-2 (-) - E26-64 (OE1-) | Always | Below 1 Ω |
| E56-1 (+) or E26-65 (OE1+) - Body ground | Always | 10 kΩ or higher |
| E56-2 (-) or E26-64 (OE1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||