DTC C1432 Steering Angle Sensor Power Source Voltage Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1432 | With the +BS terminal voltage 9.6 to 16.5 V, the steering angle sensor power supply circuit malfunction signal is received from the steering angle sensor. |
|
| 1.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL) |
![]() |
Remove the steering wheel and the column cover.
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the steering angle sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I29-5 (BAT) - Body ground | Always | 11 to 14 V |
| I29-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I29-1 (ESS) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Steering Angle Sensor) |
|
| ||||
| OK | ||
| ||