Vehicle Stability Control System
Symptom
| Suspected Area
| See page
|
ABS, BA and/or EBD does not operate.
| Check for DTCs again and make sure that DTCs are not output.
|
Click here
|
Power source circuit (Low power supply voltage malfunction)
|
Click here
|
Power source circuit (High power supply voltage malfunction)
|
Click here
|
Front speed sensor circuit
|
Click here
|
Rear speed sensor circuit
|
Click here
|
Check the brake actuator assembly using the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks.
|
Click here
|
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
ABS, BA and/or EBD does not operate efficiently.
| Check for DTCs again and make sure that DTCs are not output.
|
Click here
|
Front speed sensor circuit
|
Click here
|
Rear speed sensor circuit
|
Click here
|
Stop light switch circuit (On stuck malfunction)
|
Click here
|
Stop light switch circuit (Open malfunction)
|
Click here
|
Stop light switch circuit (Off stuck malfunction)
|
Click here
|
Check the brake actuator assembly using the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks.
|
Click here
|
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
ABS sensor DTC check cannot be done.
| Check for DTCs again and make sure that DTCs are not output.
|
Click here
|
TC and CG terminal circuit
|
Click here
|
If the symptoms still occur even after the above suspected areas has been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
ABS warning light abnormal (Remains on).
| ABS warning light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
ABS warning light abnormal (Does not come on).
| ABS warning light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
Brake warning light abnormal (Remains on).
| Brake warning light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
Brake warning light abnormal (Does not come on).
| Brake warning light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
VSC and/or TRC does not operate.
| Check for DTCs again and make sure that DTCs are not output.
|
Click here
|
Check system variant learning.
|
Click here
|
Check the engine control system.
|
Click here
|
Power source circuit (Low power supply voltage malfunction)
|
Click here
|
Power source circuit (High power supply voltage malfunction)
|
Click here
|
Check the hydraulic circuit for leaks.
| -
|
Front speed sensor circuit
|
Click here
|
Rear speed sensor circuit
|
Click here
|
Yaw rate and acceleration sensor circuit (Sensor malfunction)
|
Click here
|
Yaw rate and acceleration sensor circuit (Power supply voltage malfunction)
|
Click here
|
Acceleration sensor circuit (Comparison malfunction)
|
Click here
|
Yaw rate sensor circuit (Comparison malfunction)
|
Click here
|
Yaw rate and acceleration sensor circuit (Internal malfunction)
|
Click here
|
Steering angle sensor circuit (Output malfunction)
|
Click here
|
Steering angle sensor circuit (Power source voltage malfunction)
|
Click here
|
Steering angle sensor circuit (Internal malfunction)
|
Click here
|
Replace the ECM (for 2GR-FE).
|
Click here
|
Replace the ECM (for 2AR-FE).
|
Click here
|
Replace the ECM (for 1AZ-FE).
|
Click here
|
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
VSC sensor DTC check cannot be done.
| Check for DTCs again and make sure that DTCs are not output.
|
Click here
|
TC and CG terminal circuit
|
Click here
|
If the symptoms still occur even after the above suspected areas has been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly).
|
Click here
|
TRC OFF indicator light abnormal (Remains on).
| TRC OFF indicator light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
TRC OFF indicator light abnormal (Does not come on).
| TRC OFF indicator light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
VSC OFF indicator light abnormal (Remains on).
| VSC OFF indicator light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
VSC OFF indicator light abnormal (Does not come on).
| VSC OFF indicator light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
Slip indicator light abnormal (Remains on).
| Slip indicator light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
Slip indicator light abnormal (Does not come on).
| Slip indicator light circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|
Sensor check cannot be done.
| TS and CG terminal circuit
|
Click here
|
Skid control ECU (Brake actuator assembly)
|
Click here
|