Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1433    Steering Angle Sensor Internal Circuit

for Preparation Click here


DESCRIPTION

This DTC is stored when the skid control ECU receives an internal malfunction signal from the steering angle sensor.

DTC No.
DTC Detection Condition
Trouble Area
C1433
With the +BS terminal voltage 9.6 to 16.5 V, the steering angle sensor malfunction signal is received from the steering angle sensor.
Steering angle sensor

INSPECTION PROCEDURE

1.REPLACE STEERING ANGLE SENSOR
  1. Replace the steering angle sensor (Click here).

    HINT:
    If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (Click here).


NEXT

END