VEHICLE STABILITY CONTROL SYSTEM > Slip Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
| Result | Proceed to |
| OK | A |
| NG (for 2GR-FE) | B |
| NG (for 2AR-FE) | C |
|
| ||||
|
| ||||
| A | |
| 4.INSPECT COMBINATION METER ASSEMBLY |
Perform an Active Test of the combination meter assembly (meter CPU) using the intelligent tester (Click here).
Check the combination meter assembly.
|
| ||||
| OK | ||
| ||