Home › Engine / Hybrid System ยท 1AZ-FE › STARTING › STARTER

STARTER > INSTALLATION

for Preparation Click here



1. INSTALL STARTER ASSEMBLY
  1. Install the starter assembly with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Connect the connector.

  1. Connect the starter wire and install the nut, close the terminal cap.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }



2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY
  1. Install the air cleaner case sub-assembly with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the wire harness clamp.



3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner cap sub-assembly with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the air cleaner cap sub-assembly to the air cleaner hose, tighten the hose clamp.

  1. Connect the connector and wire harness clamp to the air cleaner cap sub-assembly.



5. INSTALL INLET AIR CLEANER ASSEMBLY
  1. Install the inlet air cleaner assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Install the No. 1 engine cover sub-assembly with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



7. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 9 clips.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).