Home › Engine / Hybrid System ยท 1AZ-FE › STARTING › STARTER

STARTER > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE COOL AIR INTAKE DUCT SEAL


    B282103
  1. Remove the 9 clips and cool air intake duct seal.



4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    A134904
  1. Remove the 2 nuts and No. 1 engine cover sub-assembly.



5. REMOVE INLET AIR CLEANER ASSEMBLY


    A264362
  1. Remove the 2 bolts and inlet air cleaner assembly.



6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A264434
  1. Disconnect the connector and wire harness clamp from the air cleaner cap sub-assembly.

  1. Loosen the hose clamp and disconnect the air cleaner cap sub-assembly from the air cleaner hose.

  1. Remove the 2 bolts and air cleaner cap sub-assembly.



7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A264522
  1. Disconnect the wire harness clamp.

  1. Remove the 3 bolts and air cleaner case sub-assembly.



9. REMOVE STARTER ASSEMBLY


    A134876
  1. Disconnect the connector.

  1. Open the terminal cap, remove the nut and disconnect the starter wire.



    A134877
  1. Remove the 2 bolts and starter assembly.