STARTER > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 9 clips and cool air intake duct seal.
| 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
![]() |
Remove the 2 nuts and No. 1 engine cover sub-assembly.
| 5. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY |
![]() |
Disconnect the connector and wire harness clamp from the air cleaner cap sub-assembly.
Loosen the hose clamp and disconnect the air cleaner cap sub-assembly from the air cleaner hose.
Remove the 2 bolts and air cleaner cap sub-assembly.
| 7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
| 8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp.
Remove the 3 bolts and air cleaner case sub-assembly.
| 9. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the connector.
Open the terminal cap, remove the nut and disconnect the starter wire.
![]() |
Remove the 2 bolts and starter assembly.