CAN COMMUNICATION SYSTEM > Audio Receiver Assembly Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Audio Receiver Assembly Communication Stop Mode | Either condition is met:
|
|


| 1.CHECK FOR OPEN IN CAN BUS LINES (RADIO AND DISPLAY RECEIVER ASSEMBLY BRANCH LINE) |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I155-9 (CANH) - I155-10 (CANL) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
Disconnect the radio and display receiver assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I152-7 (GND1) - Body ground | Cable disconnected from negative (-) battery terminal | Below 1 Ω |
Connect the cable to the negative (-) battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| I152-3 (ACC1) - Body ground | Ignition switch ACC | 11 to 14 V |
| I152-4 (+B1) - Body ground | Ignition switch off | 11 to 14 V |
| I155-1 (IG) - Body ground | ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
|
| ||||
| OK | ||
| ||