DTC B2417 Headlight Beam Level Control Motor LH Malfunction |
DTC B2418 Headlight Beam Level Control Motor RH Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2417 |
|
|
| B2418 |
|
|

| 1.CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Active Test.
Check that the leveling motors operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Drive The Leveling Motor UP | Leveling motor upward operation | ON/OFF | ON: Moves up OFF: Stops |
| Drive The Leveling Motor DOWN | Leveling motor downward operation | ON/OFF | ON: Moves down OFF: Stops |
|
| ||||
| OK | |
| 3.CHECK HEADLIGHT LEVELING MOTOR |
Replace the headlight leveling motor with a new or a known good one (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (BATTERY - AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)) |
![]() |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A35-15 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to AFS ECU (Headlight Swivel ECU Assembly)) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A35-22 (E1) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to AFS ECU (Headlight Swivel ECU Assembly)) |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT LEVELING MOTOR) |
Disconnect the LH side or RH side headlight leveling motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A35-3 (LH+) - A19-1 (LHB1) | Always | Below 1 Ω |
| A35-27 (LH-) - A19-3 (LHE) | Always | Below 1 Ω |
| A35-30 (LHE) - A19-2 (LHM+) | Always | Below 1 Ω |
| A35-3 (LH+) - Body ground | Always | 10 kΩ or higher |
| A35-27 (LH-) - Body ground | Always | 10 kΩ or higher |
| A35-30 (LHE) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| A35-4 (RH+) - A61-1 (RHB1) | Always | Below 1 Ω |
| A35-28 (RH-) - A61-3 (RHE) | Always | Below 1 Ω |
| A35-11 (RHE) - A61-2 (RHM+) | Always | Below 1 Ω |
| A35-4 (RH+) - Body ground | Always | 10 kΩ or higher |
| A35-28 (RH-) - Body ground | Always | 10 kΩ or higher |
| A35-11 (RHE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 7.INSPECT AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) |
![]() |
Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A35-3 (LH+) - A35-27 (LH-) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| A35-4 (RH+) - A35-28 (RH-) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| *a | Component with harness connected (AFS ECU (Headlight Swivel ECU Assembly)) |
|
| ||||
| OK | |
| 8.CHECK HEADLIGHT LEVELING MOTOR |
Replace the headlight leveling motor with a new or a known good one (Click here).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||