Home › Drivetrain ยท U760E AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
(Click here)


2. REMOVE TORQUE CONVERTER ASSEMBLY


    C201724
  1. Remove the torque converter assembly from the automatic transaxle assembly.



3. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    C201700
  1. Remove the 19 bolts and automatic transaxle oil pan sub-assembly from the transaxle case sub-assembly.

    NOTICE:
    Some fluid will remain in the automatic transaxle oil pan sub-assembly. Remove all the bolts, and carefully remove the automatic transaxle oil pan sub-assembly.



4. REMOVE AUTOMATIC TRANSAXLE OIL PAN GASKET
  1. Remove the automatic transaxle oil pan gasket.



5. REMOVE TRANSMISSION OIL CLEANER MAGNET


    C201701E04
  1. Remove the 2 transmission oil cleaner magnets from the automatic transaxle oil pan sub-assembly.
    Text in Illustration 
    *1
    Transmission Oil Cleaner Magnet



    AT00103
  1. Examine particles in the automatic transaxle oil pan sub-assembly.

    1. Collect any steel chips with the removed magnets. Look carefully at the chips and particles in the automatic transaxle oil pan sub-assembly and on the transmission oil cleaner magnets to see the type of wear which might be found in the automatic transaxle assembly.
      Result 
      Steel (magnetic)
      Brass (non-magnetic)
      Bearing, gear and plate wear
      Bushing wear



6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    C201702
  1. Remove the 2 bolts and valve body oil strainer assembly from the transmission valve body assembly.



    C201703
  1. Remove the O-ring from the valve body oil strainer assembly.



7. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


    C201704
  1. Remove the 11 bolts and transmission valve body assembly from the transaxle case sub-assembly.

    NOTICE:
    When removing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and the transaxle case sub-assembly to interfere with each other.



8. REMOVE NO. 1 GOVERNOR APPLY GASKET


    C201316
  1. Remove the 2 No. 1 governor apply gaskets from the transaxle case sub-assembly.



9. REMOVE MANUAL VALVE


    C201705
  1. Remove the manual valve from the transmission valve body assembly.