Home › Engine / Hybrid System ยท 2AR-FE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here


Perform "Inspection After Repair" after replacing the knock control sensor (Click here).


1. INSTALL KNOCK CONTROL SENSOR


    A212473E04
  1. Install the sensor with the bolt so that the sensor is angled as shown in the illustration.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    Text in Illustration 
    *a
    Front of Engine
    *b
    Up
    *c
    7°
    *d
    10°

    NOTICE:
    The acceptable installation angle of the sensor is between 7° upward and 10° downward from the horizontal position.

    HINT:
    Perform "Inspection After Repair" after replacing the knock control sensor (Click here)

  1. Connect the sensor connector.



2. INSTALL INTAKE MANIFOLD
(Click here)